CONTROLS & STEERING
We service, install, and maintain most types of steering and control systems.
from basic tiller steering to hydraulic steering systems and even chain drives.
We also work on most types of controls, Morse type single or twin lever, to the latest state of the art common rail Nema 2000 types
We even do stop cable installations/repairs
The marine engineers at Purbeck Marine know a huge amount about boat controls and systems as every boat that we work on have engine controls in some form or another. We know about early types all the way through to the latest state of the art electronic control systems that are out today. Being leading common rail dealers we have the equipment and knowhow to support many of the systems on the market.
we also sell controls, systems and cables with a technically backed service
Purbeck Marine can carry out works on any aspect of your steering system, being established for over 40 years we have the equipment and experience to understand old vintage type systems leading to the most modern high performance ones.
We can do chain, shaft, gear, cable and hydraulic systems and even have the Seastar bleeding kit for inboard and outboard steering systems
Purbeck Marine has lots of experience in servicing, repairing, installing and setting up rudders, and the relevant equipment attached, we do this on sailing yachts, motor boats, commercial craft and ferries. we have specialist equipment for removing most rudders and carry out works including MCA inspection and reports, wear measuring, bush manufacturing, seal/gland servicing or replacing, tiller arm and rose joint connection works, antifouling & anodes
Common Rail Support
Over the last few years Purbeck Marine Ltd based in Poole, Dorset have invested a lot of time and money into training and test equipment to be able to look after, install and repair the entire Yanmar and Nanni Common Rail engine ranges. We work closely with E.P. Barrus and A R Peachments to continually increase our knowledge and skills with their full support. We have full licence and certification to use our computer to plug into the engines ECUs to fault find and support.
This includes works on electronic control systems and electronic steering systems
we have test equipment and knowledge to setup or fault find any issues that you may be having